Tecno W3 SPD Clone

Below is the direct link to download the Tecno W3 SPD Clone Stock ROM (Firmware). Follow the instructions on how to flash this device carefully. We will not take any responsibility for whatever that may happen to your device.


Caution: Make sure you are downloading the exact firmware of the device you want to flash because flashing a wrong firmware will make the device completely dead, can’t power on, can’t charge and will not be detected by a computer.

Download Tecno W3 SPD Clone Stock ROM (Firmware)

Download Tecno W3 SPD Clone Stock ROM (Firmware)

File Name: TECNO_W3_SP7731_QT23_25_7731_V04_20160927
File Size: 703 MB
How to Flash: Follow Instruction

Download

How to Flash

Step 1: Download & extract the Stock ROM (Firmware) on your computer.

Step 2: Open the extracted folder, there you will get the firmware of the device.

Step 3: Make sure you install USB Drivers on your Computer to ensure that the device gets connected (skip this step if drivers are already installed).

Step 4: Launch the Tool required, Select the firmware and flash your device.

See Detailed Instructions

Important Notes:

[*] Take a backup: All data on your device gets wiped after flashing so take a backup of your personal data before flashing or installing the new firmware. As this ease you to recover them whenever anything wrong happens.

[*] Read flash: It is always advisable to backup the firmware of the device you are about to flash unless the device is completely dead (can't power on).

[*] Read me: Make sure you read & follow this tips & guides before you completely proceed to flashing your device. These tips are very important to be ignored.

Comments

Copyright © 2016-2019 RomShillzz.  | Teampose Inc. All Rights Reserved.